Every homeowner realizes that they require more space at some point. How can I get more space? You have two options. One, you can go outward and build an additional room. This will cost you a lot of money. Or you can look inward.
A basement is space that you have in your home. Most homeowners view the basement as a place to store junk and for essential services like the furnace or water heater. You don’t have to clear out the junk in your basement and create a family room, media area, auxiliary bedroom, or gym.
Before you can transform your basement into a living space, there are some things that you need to consider.
Get Moisture Under Control
Basement finishing is all about moisture. Basement finishing is all about managing moisture. Even features that traditionally are not supposed to go in a basement–wall-to-wall carpeting, for one–can be added with no problem.
Basements that are saturated with moisture may not be finished. Most basements are disqualified by moisture. Water-lock paint can be used to treat minor moisture issues. Special caulking can be used to seal cracks. Dehumidifiers pull in moisture-laden air, and then collect a lot of it before it can condense onto basement walls or ceilings.
You can find companies that will do this work in areas where basements are common. You can raise your flooring even if there is a little water running along the floor into a drain.
Decide the purpose of your basement
Basements are unique and not suitable for all uses. Basements are often cold, dark and isolated.
You’ll have to make sure you have enough windows and tubes if you plan on building your basement for a sun-loving relative.
Basements can be used for other purposes that don’t require much light. For better performance, home movie theaters rely on dimming the lights and dampened acoustics.
Basements are great for home gyms and yoga studios. Basements have lower ceilings so you won’t find it possible to install tall equipment.
Plan for a Prioritized Wall System
Basement walls are often installed for several reasons. Walls make the basement more attractive. They allow for easier installation of receptacles and make it easy to run wires. Walls also improve temperature control.
In finished basements, walls often lack structural value. Steel studs are a good choice because they resist rot and have perfect dimensions.
Basements are best insulated with foam insulation. Fiberglass insulation can develop mold.
Create an electrical plan
To comply with the electrical code, you will need to provide an adequate number of outlets when finishing your basement. A basement with a bathroom must have the same electrical work as the upper floors. This includes a lighting circuit, a circuit to power the bathroom exhaust fan, and GFCI outlets.
Pre-plan Heating and Cooling
Heating and cooling can work together in some homes. The basement is cool because it is below the ground. The basement stays warm in winter because earth acts as an insulation.
Most basements require some form of supplemental heating or cooling. The best way to heat quickly is with an electrical baseboard heater. Consider also the possibility that HVAC ductwork is already running above the floor joists, which you could tap into to heat your basement.
Incorporate Egress Requirements
If you want to add a bedroom to your basement remodel, egress is the exit point beyond the doorway.
Egress requirements will be required for basements that are finished and habitable. This is a requirement of most local building codes. You may have to make a window if you don’t already have enough egress points.
Make a Lighting Plan that is Effective
Basements are usually darkened by inadequate lighting. However, because of the restrictions on height, it may be impossible to install all types of lighting.
Recessed or can lights are very popular for basement remodeling chicago il. Recessed lights are a great way to get a lot of light and can be tucked into the space between the floors joists on the level above.
Basements are unable to rely on natural lighting so artificial lighting is used for most of the lighting needs. You should plan for more lighting than what you actually need. You don’t need all the lights. Use only the ones that you use.
+ There are no comments
Add yours