WINDOW WASHING TIPS AND TECHNIQUES

This is the fastest and most efficient way to clean your windows streak-free and crystal clear.

1. Basic Window Washing Equipment.

When Cleaning windows, Remember that professional window washers can be purchased online, at in-home centers, and at full-service hardware shops. Here are the essentials:

• 10- or 12-in. squeegee
• A sponge or a scrubber
• A bucket (a 5-gallon bucket of plastic will work)
• Dish soap
• Small towels or rags that are lint-free
• If necessary, a ladder and a ladder stabilizer

Make sure your squeegee is fitted with a new, sharp rubber blade. Keep a few extra rubber blades on hand. Blades that have not been nicked or sliced can be used for a lot longer by simply being reversed to reveal a new edge. Make sure the blade is not touched when you store your squeegee.

2 .DIY Window Cleaning Solution.

The best Window cleaning solutions are made at home. You can simply mix two gallons of water with about one teaspoon of dishwashing detergent in a bucket. Others may also use the mixture. Use vinegar and water to clean your windows. In warm weather, and cool water will give you a bit more time to wash your windows. If you have procrastinated for so long that your windows aren’t being washed in cold temperatures, you can add a windshield washing solution to ensure the water doesn’t freeze.

3. Scrub The Glass.

The first step towards the Exterior window The glass should be cleaned by scrubbing it at all angles. You should cover every inch of the glass. This will allow you to achieve amazing results quickly. The squeegee is being moved horizontally across the glass. However, vertical strokes are also possible. To direct excess water towards the area that isn’t cleaned, angle your squeegee vertically.

4. Clean A Start Strip.

Turn the squeegee to ensure that the glass touches only one corner. Next, start at the top corner and clean one side of the glass. This will make it easier to begin the horizontal strokes.

5.  Use A Squeegee To Smoothen The Top.

The squeegee blade should be pressed against the glass at the upper corner. Continue to pull the squeegee across the window. Keep the top of your squeegee in direct contact with the window. Edge of the window.

6.  Clean The Squeegee.

To remove excess water and dirt, wipe the blade with a clean towel.

7.  Get Rid Of The Window.

Start over, with the top edge of the squeegee covering the stroke approximately 2-in. To direct water down, angle the squeegee so that it is positioned across the window. Repeat the process.

8. Get Rid Of Excess Water.

Next, use the rag from your pocket to clean the windows’ bottom edges. To remove any suds, you can poke your finger into the dry spot on a separate, lint-free cloth and then run it around the perimeter. Use a clean, lint-free cloth to remove any streaks. If you are unable to find fresh, clean areas, change rags.

9.  A Squeegee Can Be Used Inside The House, Too.

Professional cleaners use squeegees in every room, even inside houses. Stain and varnished woodwork. To avoid excessive dripping or running when cleaning windows indoors with a squeegee, squeeze as much soapy water from the scrubber as possible. Place the scrubber on the bucket’s edge rather than dipping it into the water after each window. You may be able to wash 5-10 windows, depending on the condition of your windows. To wipe the edges of the glass, use a separate clean cloth. For window cleaning in christchurch , microfiber rags are also great.

10.  How To Change A Squeegee Blade.

• Take out the worn blade.
• Grab the blade’s end and pull it out until you see the metal clip.
• Slide the clip off and then slide the blade out of the other end.
  • Tip: Blades that aren’t clipped are often held together with a few screws and the clamp attached to the handle.
• Install the new blade.
• Place it in the metal channel.
• It can be stretched and then reattached to the metal clip.
  • Tip: Leave 1/8 to 3/16 inches at the blade’s end. The channel should protrude from it.

11.  Tips For Cleaning Windows That Are Difficult To Clean.

Use a razor blade that is mounted in a holder to remove paint specks or labels. To avoid scratching the glass, always use a new blade. First, wet the glass and then push the blade along the glass. To avoid catching debris underneath the blade, which could scratch the glass, rinse the blade. Tempered glass is not suitable for use with a razor blade.

• Use a nylon scrub pad made of fine (white) nylon to remove tree pitch and bug droppings. To avoid scratching the glass, first wet it.
• Remove tough glass stains or mineral deposits from shower doors with mild household abrasives. You can also use an ordinary power drill to clean other glass surfaces.
• This glass cleaner is for stubborn spots: To remove greasy dirt, add 1/2 cup ammonia to a gallon of water.
• Remove sticky residue from tape labels and tape by soaking them in a special product such as Goof Off. Goof Off is available at hardware stores and home centers in the paint section. Use a razor blade to scrape the residue.